Filter
Top Products
36 78-8130-6151-8-E
Writing iD Markers
The Write Mode enables the user to write or program information into 3M
™
EMS iD
Markers. It is also possible to edit the information to be programmed.
Menu [6] + Write Mode [SK]
1. Select a template from the list on the screen to
be programmed into the marker by pressing the
up/down arrows [SK] to highlight the preferred
template. ‘Last Written’ is the most recent
data that was programmed to a marker by the
receiver.
2. Press View/Edit [SK].
− The screen will display the information from
the selected template. The arrow on the right
side of the screen indicates there is more
information than can be displayed on the
screen (scroll down by pressing the down
arrow [SK]).
3. Enter user information that will be written to
this marker. (See Modifying Marker Data to be
Programmed section.)
4. Verify all information is correct.
5. Press Write Marker [SK].
6. Select type of marker to be written Marker [SK
Toggle].
7. Hold the receiver directly over the top of the
marker. The receiver should be within 12 inches
(30 cm) of the marker.
8. Press Start Write [SK].
− The receiver will ask if the user wants to
permanently lock the marker data.