Filter
Top Products
30 78-8130-6151-8-E
− The screen will return to Special Peak Cable
Locate / Alert On.
− If the selected type of utility marker is
detected, a second audio tone will emit from
the unit and the marker bar graph will fill.
The marker utility will default to the last
type of marker set in marker locate mode.
6. Press Locate [5] + Marker [SK] + Marker 1 [SK
Toggle] to change the type of marker that the
unit will detect in alert mode,
Single Marker Locate
1. Press Locate [5]
2. Press Marker [SK]
3. Press Markr 1 [SK Toggle] to select desired
utility.
4. Markr 2 should be OFF.
Note: Only the marker types enabled in the setup
menu will be shown. (See Enabling/Disabling
Marker types). When scanning for markers, the gain
level [12] should be set high.
− When a marker is detected, adjust the Gain
Down [4] until the bar graph opens.
− The bar graph will close, the audio will
be steady, and the signal strength will be
maximum when the receiver detects a marker
of the specified utility.
Dual Marker Locate
1. Press Locate [5].
2. Press Marker [SK].
3. Press MARKR 1 [SK Toggle] to select desired
Utility.
4. Press MARKR 2 [SK Toggle] to select desired
Utility.
Note: Only the marker types enabled in the setup menu will be shown.
− The third and fourth soft key commands will populate with the types of utilities
selected for Marker 1 and Marker 2.