DART 300 Migration Guide Comparative AT Command Reference
2110291 Rev 1.0 Page 34
4.4.2. WS-Registers in the DART 300
This section provides a cross reference from the DART 300’s +WS register set to the equivalent
DART 200 commands or registers.
Table 4-9: WS-Registers
Register DART 200 Equivalent DART 300
45
*A
for server side and
T
or
P
dial modifier for
client side.
PAD – Packet Service
50
Not supported. Normalized Signal Strength
56
S57
bit 0
Network Registration Status
60
Not supported. Time Independent Escape Sequence (TIES)
62
Command
F
(Echo Data State).
PAD Local On-Line Echo
63
\M
for bit 0 equivalence (enabling)
\F
for bit 1 equivalence (inclusion)
PAD Forwarding Character Feature Mask
64
S51
or
S52
; the DART 300 only supports one
forwarding character.
PAD Primary Forwarding Character
70
S50
to set the timer.
\T
to enable or disable use.
PAD Inter-Character Timer
72
Not supported. PAD Input Buffer Editing Enable
73
Not supported. PAD Input Buffer Backspace Character
74
Not supported. Fixed at 1924. PAD Maximum Packet Length
173
Registration Control
Supported via
\R4
for auto-registration and
\R2
for “manual” registration (automatic with
dial). Settings can be queried at
S57
.
Registration Mode
174
Supported with
\N
.
Channel Side A/B Preference
175
Not supported. CDPD Sleep Idle Time
176
Supported using the
\S
command.
Auto-register NEI Index
179
Not supported. Registration Wait Status
197
Supported using the
\S
command.
Active NEI Index
198
Supported in register
S13
.
Registration Wait Time
200
Supported in register
S100
.
Current Channel Number
201
Result codes are reported in
S56
.
Registration progress is reported in
S126
.
Registration Progress and Result Codes
209
Not supported. Radio Temperature
210
Supported in register
S110
.
Cell Number
212
Supported by command
*L
.
Listening Port
213
Not supported. Friend List Index
217
Register
S83
contains the timer.
Bit 2 of
S82
enables the feature.
UDP Server Receive Lock
