DART 300 Migration Guide Comparative AT Command Reference
2110291 Rev 1.0 Page 32
Table 4-8: S-Registers (continued)
Register DART 200 DART 300
52
PAD Primary Forwarding Character 2
Not supported. The DART 300 has only one
Primary Forwarding Character (+WS64).
53 IP Address and port number of current
TCP/UDP session partner.
Not supported. The IP address can be
obtained with +WVCALLERIP. The port
number is not available.
57
State information (bitmapped)
Not supported. The various elements reported
by the DART 200 can be queried on the
DART 300 using the command equivalents:
b0,1 = +WS56? (registration status)
b2,3 = not supported (Use DCD)
b4,5 = +WS173? (auto-registration)
b6 = not supported (auto-SLIP)
b7 = +WPRSSI (coverage/
chan acquisition.)
56 Last registration result code received from the
network.
Not supported. Registration progress is
available from register +WS201. The values
have different meanings from those of the
DART 200.
58
PAD status (bitmapped)
Not supported. The various elements reported
by the DART 200 can be queried on the
DART 300 using the command equivalents:
\T = +WS70? (PAD frwd timer)
\M = +WS63? (Pri. frwd. char)
\Q = -none- (Always H/W flow)
\F = +WS63? (Pri. frwd. char)
\O = -none- (no Telnet support)
62
Connection Failure Not supported.
63
Connection Failure Probable Cause Not supported.
70
PING Wait Timeout Not supported.
71
PING Data Length Not supported.
77
Telnet Escape Character Not supported.
78
Telnet Starting Terminal Type Not supported.
79
Graceful TCP Shutdown (bitmapped)
Not supported. The DART 300 always
attempts graceful shutdown of TCP sessions.
82 Friends Only and UDP Controls (bitmapped)
(Service Provider Mode)
Friends Only and UDP Controls
The features are available with various
commands as follows:
b0 = +WVFRIEND= (friends only)
b1 = not supported
b2 = +WS217 (UDP receive lock)
b3 = not supported
b4 = not supported
Client sessions only support traffic with the
destination server.
