Sierra Wireless 20070914 Manual

A SERVICE OF

next previous

Global Positioning System (GPS)

Rev 3.0B Feb.08 102

• SRM(SetReportingMode)allowstheclienttosetthe

reportingmodeconfiguration.Thereportmodeconfigu

‐

rationisnotstoredinnon‐volatilememoryand such

shouldberesentuponaunitreset.Thisbehavioremulates

thatspecifiedinTAIPspecifications.

• QRM(QueryReportingMode)reportsthereportingmode

configuration(returnsan“RRM”message).

• SID(SetID)allowstheclienttosettheTAIPID

(AT*PPTAIPIDcanalsobeusedtosettheTAIPID).The

TAIPID,whensetwitha“SID”message,willbewrittento

non‐volatilememory.

• QID(QueryID)reportstheTAIPID(returnsan“RID”

message).

• DPVconfiguresautomaticreportingofPV(Position/

Velocity)reportsbasedondistancetraveledanda

maximumtime.Thedeltadistancevaluespecifiedinthe

messageisconvertedtohundredsofmetersandstoredas

*PPDIST.Themaximumtimeintervalisstoredas

*PPTIME.Currentlytheminimumtimeandepochvalues

are

ignored.

• FPVconfiguresperiodicreportingofPV(Position/

Velocity)reports.Thetimeintervalfromthemessageis

storedat*PPTIME.Currentlytheepochvalueisignored.

• QPV(QueryPositionVelocity)respondswithaPV

(Position/Velocity)report.

TheTAIPemulationwillgeneratethefollowingreportscorre‐

spondingtotheappropriateevent(eitheraqueryforit,echoed

duetoaset,orduetoanautomaticreportingevent):

• RRM(ReportReportingMode)reportsthereporting

modeconfiguration.

• RID(ReportID)reportstheTAIPID.

• RPV(ReportPosition/Velocity)reportsPosition/Velocity.

Messages Over-the-Air (Remote)

ToconfigurethePinPointXtosendNMEAreportstoaremote

server,youwillneedtoset3commands:*PPIP,*PPPORT,and

*PPGPSR.

a. Set*PPIPand*PPPORTtotheIPaddressandportof

theservertowhichyouwantthereportssent.

Figure 10-34: AceManager : PinPoint - *PPIP/*PPPORT