A SERVICE OF

logo

\text\etd\DA615\Error 8.1 DA615 instruction manual
8. Error messages and hints
General error messages
Error message Cause Solution
ERROR LCA !!
CALL SERVICE
Error in loading the
hardware into the XC5206
module.
- Check the connection on
or to the print board.
- Check the module
ERROR LCA# Ready
CALL SERVICE
# = Number 1-4 specifies which module
is responsible for this error.
Printing error – the
XC5206 module does not
confirm successful
completion of the print
operation.
XC5206
- Check the print-head.
- Check that the correct
firmware was loaded.
NO PAPER !!
Paper has run out. Insert new paper
PAPER JAM !!
REMOVE PAPER
Paper is jammed. Remove jammed paper and
readjust the paper feed
mechanism (see Sect. 3).
POSITION ERROR !!
CHECK TOP MARGIN
The printed area is
outside the paper format.
The light barrier for paper
detection is not working
properly.
Check the light barrier.
Reduce the "Top margin"
setting with the "ð
ðð
ð" key or
in programming mode, or
correct the paper size (see
Sect. 5).
Check the paper for black
areas.
NO INK !!
CHANGE PRINTHEAD
The cartridge is empty. Replace the cartridge (see
Sect. 4).
CHECKSUM ERROR !!
MAKE DEFAULT RESET
Error in the buffered
RAM (module M48Z58).
Reset to default value (see
Sect. 5).
Replace module M48Z58.
CHECKSUM ERROR !!
MAKE COUNTER RESET
CHECKSUM ERROR !!
TESTMACRO RESET
CHECKSUM ERROR !!
SETTING RESET