Printer functions
\text\etd\DA615\printerf
5.12 DA615 instruction manual
H2 = Head 2
H4 = Head 4
1 5 10 15 20 3 5 10 15 20 12
H2
1 5 10 15 20 3 5 10 15 20 12
H4
–
the contacts to all nozzles, addressed individually in sequence, are
displayed in a continuous oblique line.
H1
H2
H3
H4
Char Print-out of the currently defined character set.
HexD
Hex Dump causes all received characters to be printed from the
receive buffer in LetGot12.
Hex Dump is terminated with the PROG, END or START keys.
☞
Hex Dump may also be initiated directly by keeping the START
key pressed down when the printer is switched on. Do not
terminate Hex Dump by switching off the printer as this may lead
to changes in the settings!!
InpD In Inp-Dump, all 96 kbytes of the receive buffer are printed with PC8
symbols.
NOTE ! The entire print-out requires about 30 DINA4 pages. Switch the
printer off and then on again, send the print job and then start the
dump print-out. The required data is now located at the beginning
of the buffer. As soon as it has been printed out, you may stop
further printing.
SetD
The 10 printer settings that are activated under each number in the
“Setting” option are printed out.
To do this, you will need nine sheets with minimum dimensions (LxW)
160 x 50 mm (6.3x2“). They are not pulled in until after the “SetD“
instruction has been given.
The following page shows a complete SetD print-out.
