A SERVICE OF

logo

10 | C1508M-A (02/01)
4.3 SERCOM BOARD CARDS
Sercom Card installation at the factory configures the Sercom cards for the slot position lo-
cations they occupy in the unit.
Once you have an operational system, you can cycle through your IRQ/Slot position set-
tings by toggling the ALT + A key combination on the keyboard associated with the diagnos-
tic screen.
4.4 MOUNTING THE CONTROLLER
The CM9740-CC1 Controller mounts in a standard 19-inch rack using standard mounting
hardware (supplied with the unit). The unit occupies 3 RU (5.25 inches [13.34 cm]) of verti-
cal rack space.
Before installing the unit, decide on the equipment orientation desired within the EIA rack
and install the moveable ears on the unit accordingly. Secure as required.
WARNING:
Un-
plug the CC1 before
attempting to install
or remove any of the indi-
vidual components. Failure to
do so could result in serious
damage to the equipment.