66
66
Figure 1. Programming the remote to control your Net-
Command™ A/V devices.
Part IV: Operation
Programming Remote Control
Programming the Remote Control to Control NetCommand
™
A/V
Products
To Program the Remote to Control
NetCommand A/V Products:
(See NetCommand Supported Devices, page 16, for
the list of A/V products supported by the NetCom-
mand System.)
Move the slide switch at the top of the
remote to the TV layer.
Press and hold the POWER button on
the remote control.
Enter the three digit code of 935, and
then release the POWER button on the
remote control.
The remote control is now programmed
to send NetCommand™ signals to the
TV so the TV can control the IEEE
1394 devices and selected older Net-
Command™ supported IR devices. See
the NetCommand™ guide for details.
