23
23
Part II: Installation
Connecting an External DTV Receiver
Connecting an External DTV Receiver
External DTV Receiver with RGB
Video Connections
(Figure 1)
Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the
DTV receiver (see your DTV receiver’s
owner’s guide for instructions, and cable
compatibility).
Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the
TV back panel (a coaxial splitter, avail-
able at most electronic supply stores,
may be required to complete this instal-
lation).
Connect the RGB cables for the DTV
receiver to the Input-DTV on the TV
back panel. You may need to set the
Input-DTV assignment to RGB using the
“Change” option of the Edit Setup menu.
Select this device to change and this
assignment will be available.
DTV Receiver TV Back Panel
G (green) = Y/G
R (red) = Pr/R
B (blue) = Pb/B
If the DTV receiver has outputs for H
and V sync, connect as listed below
(DO NOT connect if DTV receiver uses
“Sync on Green”):
H (horizontal sync) = H
V (vertical sync) = V
Connect the L (left) and R (right) audio
cables from the DTV receiver to Input-
DTV AUDIO on the TV back panel.
To utilize the bene ts of a digi tal A/V
receiver, connect your DTV receiver’s
digital audio out to a digital input on your
digital A/V receiver.
Figure 1. Connecting the DTV receiver with RGB video
connections.
See Appendix B, page 73, for RGB video
signal compatibility information.
For digital audio connections, see your
DTV receiver and A/V receiver Owner’s
Guides.
AUDIO
L
R
H
V
G
R
B
S-VIDEO
VCR
CONTROL
DIGITAL
AUDIO OUT
PHONE JACK
RF
REMOTE
SATELLITE IN
IN FROM ANT
OUT TO TV
CH 3
CH 4
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
White
Red
4
3
5
6
7
6
7
8
8
8
8
3
4
5
TV back panel
2
Incoming Antenna,
or Cable.
2
