8
8.9 When Incorrect Copies Are Produced
8-26
When a Message Appears Chapter 8
8.9 When Incorrect Copies Are Produced
* If the problem is not corrected even after the operations described above are
performed, contact your service representative.
Symptom Possible Cause Action
The printed output is too light. The density level for the Auto
setting is set to “LIGHT”.
Adjust the setting for DENSITY
LEVEL (A) in the Utility mode.
(p. 7-22)
Otherwise, cancel the “Auto”
density setting, and then
manually select the desired
density setting. (p. 4-11)
The density level is set to
“LIGHT”.
Press the [Ö ] key, and then
select a darker print density.
(p. 4-11)
Does the message “TONER
EMPTY” or “TONER NEAR
EMPTY” appear in the Display?
Replace the Toner Cartridge
with a new one. (p. 8-6)
The paper is damp. Change the paper.
The printed output is too dark. The density level for the Auto
setting is set to “DARK”.
Adjust the setting for DENSITY
LEVEL (A) in the Utility mode.
(p. 7-22)
Otherwise, cancel the “Auto”
density setting, and then
manually select the desired
density setting. (p. 4-11)
The density level is set to
“DARK”.
Press the [ ] key, and then
select a lighter print density.
(p. 4-11)
The printed output is blurry. The paper is damp. Change the paper.
Ö
