47
1. To throttle bodies connector (Gray).
2. Crankshaft Sensor Connector (Brown)
3. Battery Ground Cable (Use Original Part)
4 Frame Ground
5. Regulator
6. Starter Relay
7. To front sub harness connector (26031-0307 or 26031-0308).
8. Camshaft Position Sensor (Gray)
9. Ignition Coils (Gray)
10. Water Temperature Sensor (Black)
11. Vehicle-down Sensor (Gray)
12. Fuel Pump (Black)
13. To battery Ground terminal (Semitransparent)
14. Auto Shifter (Yellow)
15. Auto Shifter (Blue)
16. To speed sensor connector (Black).
17. Speed Sensor (Original)
18. To gear position switch connector (Green)
19. Gear Position Switch Lead (Original)
Remove the original main harness from the frame.
Install the kit main harness (26031-0328) as shown in the illustration.
Connect the [2] crankshaft sensor connector to the original crankshaft sensor connector.
Use the original part for the [3] battery ground cable.
Connect the [8] camshaft position sensor connector to the camshaft position sensor at
the cylinder head front side.
Use the original part for [9] ignition coil connector at the cylinder head upper side.
Connect the [10] water temperature sensor connector to the water temperature sensor at
under the #1. #2 intake ducts of cylinder.
When using the recommended auto shifter to connect the [15] auto shifter connector. Do
not use the [14] auto shifter.
NOTE
○ When using the kit tachometer, always connect the water temperature sensor at the
cylinder head rear side.
○ For recommended auto shifter, refer to the Kawasaki FI Calibration Tool Instruction
Manual of another sheet.
