A SERVICE OF

logo

45
Throttle Bodies
1. Injector #1
2. White Tape
3. Injector #2
4. Injector #3
5. Injector #4
6. Inlet Air Temperature Sensor (Black)
7. Main Harness (Brown)
8. Main Throttle Sensor (White)
9. Inlet Air Pressure Sensor (Black)
10. Subthrottle Sensor (Black)
11. Subthrottle Valve Actuator (Black)
Remove the original sub harness (26031-0195) from the throttle bodies.
Install the kit sub harness (26031-0329) as shown in the upside illustration.
NOTE
Injector lead connector #1 marked the white tape.
Install the bands same position after install the kit sub harness, however clamp the band
so that the harness tube are not crush.
Be careful that the sub harness does not to interference the throttle cables.