Ozone Emission
The HP LaserJet 6P and 6MP printers do not use high-voltage corona
wires in the electrophotographic process, and therefore, generate no
measurable ozone gas (O
3
). These printers instead use charging rollers
in the toner cartridge and in the print engine.
ENERGY STA R Computers Compliance
The HP LaserJet 6P and 6MP printers are designed to conserve
electricity by dropping from 175 W while printing to 8 W when in the
Power Save Mode. The instant-power-save/instant-on capability of
these printers makes a standby mode unnecessary. For maximum
energy conservation, Hewlett-Packard recommends that the printer be
turned off when it will not be used within a few hours. With this new,
power-saving design, both models of the printer qualify for
E
NERGY STAR Computers compliance. As an ENERGY STAR Partner,
Hewlett-Packard has determined that this product meets the
E
NERGY STAR guidelines for energy efficiency.
LED Safety
The infrared port on the front panel of the printer is classified as a Class
1 LED (Light Emitting Diode) device according to International
Standard IEC 825-1 (EN 60825-1). This device is not considered
harmful, but the following precautions are recommended:
• If the printer requires service, contact an authorized HP service center.
• Do not attempt to make any adjustment of the printer.
• Avoid direct eye exposure to the infrared LED beam. Be aware that the
beam is invisible light and cannot be seen.
• Do not attempt to view the infrared LED beam with any type of optical
device.
A-4 Printer Specifications EN
