Registration page
The registration page prints a horizontal arrow and a vertical arrow that show how far from
center an image can be printed on the page. You can set registration values for a tray to
center images on the back and front of a page. Setting the registration also allows edge-to-
edge printing to be set to within approximately 2 mm (0.08 inch) of all edges of the paper.
Image placement varies slightly for each tray. Perform the registration procedure for each
tray.
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight PRINT QUALITY.
5. Press
to select PRINT QUALITY.
6. Press
to highlight SET REGISTRATION.
7. Press
to select SET REGISTRATION.
NOTE
You can select a tray by specifying a Source. The default Source is Tray 2. To set the
registration for Tray 2, go to step 12. Otherwise, proceed to the next step.
8. Press
to highlight Source.
9. Press
to select Source.
10. Press
or to highlight a tray.
11. Press
to select the tray.
After selecting the tray, the printer control panel returns to the SET REGISTRATION
menu.
12. Press
to highlight PRINT TEST PAGE.
13. Press
to select PRINT TEST PAGE.
14. Follow the instructions on the printed page.
Event log
The event log lists the printer events, including printer jams, service errors, and other printer
conditions.
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight DIAGNOSTICS.
3. Press
to select DIAGNOSTICS.
4. Press
to highlight PRINT EVENT LOG.
5. Press
to select PRINT EVENT LOG.
The message Printing... EVENT LOG appears on the display until the printer finishes
printing the event log. The printer returns to the Ready state after printing the event log.
ENWW Troubleshooting information pages 179
