2About Your Pro64 Product
RCI Remote Control Interface Features:
Any number of RCI modules can be installed in a Pro64 •
network
Four Control Groups •
Headphone monitor with level control •
Rear‑panel XLR line‑level output for monitoring selected •
mic preamp channel
Pad switch for XLR line‑level output•
Backup DC power connector •
MCS Mic Control Surface Features:
Full real‑time control of the selected channel’s gain, phase, •
mute, pad, +48V phantom power, and low cut filter
Real‑time metering of 64‑channel network stream•
Intuitive user interface with numeric keypad•
High resolution metering of selected channel•
Access to all Pro64 network audio resources•
Switchable peak hold•
Save and recall of 6416m presets•
Monitor up to 64 active Pro64 network channels •
simultaneously
Simple Cat‑5e connection to RCI •
Can be used simultaneously with • m‑control
The EtherCon Connector
Pro64 Series products feature locking connectors for all network I/O. The
Neutrik® EtherCon connector is a dual RJ45‑type connector that can receive
a standard Category 5e cable or a cable fitted with the special locking
EtherCon connector.
When using a standard Cat‑5e cable, plug the cable into the center of the
EtherCon jack; release the cable by pressing on the small plastic tab built into
the cable connector.
The locking EtherCon connector is similar to an XLR plug, the kind commonly
used on microphone cables. Insert an EtherCon‑equipped cable into the
jack until it clicks and locks in place. To remove the cable, press on the metal
release tab at the top of the panel‑mounted EtherCon jack and pull the
connector outward.
