Yard Machines 690 Thru 699 Lawn Mower User Manual


 
3
Your mower is designed to cut normal residential
grass of a height no more than 10". Do not attempt to
mow through unusually tall, dry grass (e.g., pasture)
or piles of dry leaves. Debris may build up on the
mower deck or contact the engine exhaust
presenting a potential fire hazard.
2. SLOPE OPERATION
Slopes are a major factor related to loss of control and tip-
over accidents which can result in severe injury or death. All
slopes require extra caution. If you cannot back up the slope
or if you feel uneasy on it, do not mow it.
For your safety, use the slope gauge included as part of this
manual to measure slopes before operating this unit on a
sloped or hilly area. If the slope is greater than 15° as shown
on the slope gauge, do not operate this unit on that area or
serious injury could result.
DO:
Mow up and down slopes, not across.
Remove obstacles such as rocks, limbs, etc.
Watch for holes, ruts or bumps. Uneven terrain could
overturn the machine. Tall grass can hide obstacles.
Use slow speed. Choose a low enough gear so that
you will not have to stop or shift while on the slope.
Always keep machine in gear when going down
slopes to take advantage of engine braking action.
Follow the manufacturer’s recommendations for
wheel weights or counterweights to improve stability.
Use extra care with grass catchers or other
attachments. These can change the stability of the
machine.
Keep all movement on the slopes slow and gradual.
Do not make sudden changes in speed or direction.
Rapid engagement or braking could cause the front
of the machine to lift and rapidly flip over backwards
which could cause serious injury.
Avoid starting or stopping on a slope. If tires lose
traction, disengage the blade(s) and proceed slowly
straight down the slope.
DO NOT:
Do not turn on slopes unless necessary; then, turn
slowly and gradually downhill, if possible.
Do not mow near drop-offs, ditches or embankments.
The mower could suddenly turn over if a wheel is
over the edge of a cliff or ditch, or if an edge caves in.
Do not mow on wet grass. Reduced traction could
cause sliding.
Do not try to stabilize the machine by putting your
foot on the ground.
Do not use grass catcher on steep slopes.
3. CHILDREN
Tragic accidents can occur if the operator is not alert to the
presence of children. Children are often attracted to the
machine and the mowing activity. Never assume that children
will remain where you last saw them.
Keep children out of the mowing area and in watchful
care of an adult other than the operator.
Be alert and turn machine off if children enter the
area.
Before and when backing, look behind and down for
small children.
Never carry children, even with the blades off. They
may fall off and be seriously injured or interfere with
the safe machine operation.
Never allow children under 14 years old to operate
the machine. Children 14 years and over should only
operate machine under close parental supervision
and proper instruction.
Use extra care when approaching blind corners,
shrubs, trees or other objects that may obscure your
vision of a child or other hazard.
Remove key when machine is unattended to prevent
unauthorized operation.
4. SERVICE
Use extreme care in handling gasoline and other
fuels. They are extremely flammable and the vapors
are explosive.
Use only an approved container.
Never remove fuel cap or add fuel with the engine
running. Allow engine to cool at least two minutes
before refueling.
Replace fuel cap securely and wipe off any spilled
fuel before starting the engine as it may cause a fire
or explosion.
Extinguish all cigarettes, cigars, pipes and other
sources of ignition.
• Never refuel the machine indoors because fuel
vapors will accumulate in the area.
Never store the fuel container or machine inside
where there is an open flame or spark, such as a gas
hot water heater, space heater or furnace.
Never run a machine inside a closed area.
To reduce fire hazard, keep the machine free of
grass, leaves or other debris build-up. Clean up oil or
fuel spillage. Allow machine to cool at least 5
minutes before storing.
Before cleaning, repairing or inspecting, make
certain the blade and all moving parts have stopped.
Disconnect the spark plug wire, and keep the wire
away from the spark plug to prevent accidental
starting.