Filter
Top Products
Self-Tapping Self-Tapping
Screws
Belt Keeper
Assembly
RearDriveBelt
• First remove the front drive belt as instructed in the
previous section.
• Disconnect the spring which secures the idler
pulley to the frame. See Figure 32.
• Remove the transmission cover by unscrewing the
two knobs and removing two machine screws.
• Roll the belt over the top of the transmission pulley.
Remove belt from the variable speed pulley.
• Reassemble the new belt.
Pins
Figure 31
• Raise and block the front wheels of the tractor so
you can work under it.
• Remove the four self-tapping screws which hold
the belt keeper assembly to the frame at the engine
pulley. Push the belt keeper assembly forward and
out of the way. See Figure 31.
• Remove the two pins which act as belt keepers by
the variable speed pulley, for the location of the
variable speed pulley, see Figure 32.
• Roll the belt offthe variable speed pulley, then
remove from the engine pulley.
• Reassemble the new belt.
@
Spring Speed
Pulley
Pulley
Figure 32
SECTION9: OFF-SEASONSTORAGE
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
• Clean the engine and the entire unitthoroughly.
• Lubricate all lubrication points. Wipe the entire
machine with an oiled rag to protect the surfaces.
• Refer to the engine manual for correct engine
storage instructions. The engine must be
completely drained of fuel and a fuel stabilizer used
to prevent gum deposits from forming on essential
carburetor parts, fuel lines and fuel tanks.
• Charge the battery fully. Remember that the battery
loses some of its charge each day when the unit is
not used. NEVER store battery without a full
charge. Recharge battery before returning to
service or every two months, whichever occurs first.
• When storing unitfor extended periods, disconnect
battery cables. Removing battery from unit is
recommended.
• Store unit in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
23