Filter
Top Products
Beforetheunitcanbeshiftedintoreverseorifthe
operatorleavestheseat,theliftlevermustbeinthe
BLADESSTOPposition.
IndicatorLights(.Equipped)
If your unit is equipped with indicator lights, two or three
indicator lights are located in the dash panel. If a light
illuminates when attempting to start the unit, proceed
as follows.
CLUTCH--Depress the clutch pedal.
PTO--Place lift lever in the BLADES STOP position.
OIL (Vanguard Twin and Intek twin Engines Only)-
Check the crankcase oil level, and add oil as required.
CuttingControls
Lift Lever
The lift lever is used to raise and lower the cutting deck
and to engage and disengage the blades. Pulling it all
the way back and locking it disengages the blades.
NOTE: The lift lever must be in the BLADES STOP
position when starting the engine, when shifting into
reverse and if the operator leaves the seat. See Figure
11.
DeckLift Indicator(If Equipped)
If so equipped, the deck lift indicator marks the position
being used for the lift lever. Select the lift lever position
desired, press the indicator lever outward, move it to
the position immediately below the lift lever and release
the indicator lever. See Figure 11.
SettingThe CuttingHeight
Select the position for the lift lever which gives the
desired cutting height. Move the deck lift indicator
(if so equipped) so that the lift lever can be returned
to the same position after it is raised.
Move the deck wheels to the hole location so the
wheels are 1/4 inch above the ground. Place all
four wheels in the same relative position.
Lift Lever
o t
Deck Lift
Indicator
Figure 11
SECTION3: OPERATINGYOURLAWNTRACTOR
AVOIDSERIOUSINJURYORDEATH
Go up and down slopes, not across, avoid sudden
turns.
Do not operate the unit where it could slip or tip.
If machine stops going uphill, stop blade(s) and
back downhill slowly.
Do not mow when children or others are around.
Never carry children.
Look down and behind before and while backing.
Keep safety devices (guards, shields, and
switches) in place and working.
Remove objects that could be thrown by the
blade(s).
Know location and function of all controls.
Be sure blade(s) and engine are stopped before
placing hands or feet near blade(s).
before leaving operator's position, disengage
blade(s), place the shift lever in neutral, engage
brake lock, shut engine off and remove key.
READ OPERATOR'S MANUAL
13
GasAndOilFill-up
Check the oil level and add if necessary. Service
the engine with gasoline as instructed in the
separate engine manual packed with your tractor.
Read instructions carefully.
IMPORTANT:Your tractor is shipped with oil; however
you must check the oil level before operating. Be
careful not to overfill.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources
of ignition
BeforeStartingEngine
,_ WARNING: Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.