Filter
Top Products
12
Attaching Wheels
The three holes on each side of the front and rear of the cutting deck provide three adjustable cutting height
positions for the mower. Attach all four wheels at the same relative position for an even cut.
Attaching front wheel
You will find the wheels among the loose parts and the necessary hardware in the hardware pack.
• Block the front of the mower securely.
• Place the axle bolt through the front wheel with the hub side of the wheel facing the deck.
• Place the small bell washer on the axle bolt with the crown side towards the wheel. See Figure 11.
• Insert the larger bell washer and the hex nut from inside the deck and tighten the bolt. See Figure 11.
• Attach the other front wheel in the same way.
• Remove the blocks.
FIGURE 11
Attaching Rear Wheels
You will find the wheels among the loose parts and the necessary hardware in the hardware pack.
• Block rear of the mower securely.
• Place one wave washer and then one large flat washer on the rear axle bolt with the cupped side of the
wave washer against the flat washer. See Figure 12.
FIGURE 12
Place small bell
washer here
Attach wheel here
Secure wheel with
axle bolt and hardware
Axle Bolt
Wave
Washer
here
Flat Washer