Filter
Top Products
10
FIGURE 6
• Secure the cable to the lower left handle near the base of the unit with a cable tie. Insert the cable tie
through the second hole on the left handle bracket and wrap around the lower handle making sure to keep
the cable inside this ring. Pull the cable tie and trim off extra. See Figure 7.
FIGURE 7
Attaching Blade Control Handle
Reattach the blade control handle if, during shipping or unpacking, it got detached from the upper handle.
• Place the blade control handle flat against the upper handle. The ends of the blade control handle will
approximate two corresponding holes on the upper handle. Locate these holes.
• Insert the curved end of the blade control handle into the right hole. See Figure 8.
• Squeeze the handle in and insert the straight end of the blade control handle into the left hole of the upper
handle.Squeeze the blade control handle against the upper handle to check for proper assembly.
FIGURE 8
Z Fitting
Blade Control
Handle
Upper Handle
View from other side
Z Fitting
Insert cable
this hole on
Cable Tie
To cable tie
To lower handle
To rear wheel
To lower
handle &
deck
tie through
bracket
To
deck
Insert curved
end here