Filter
Top Products
20
Gel String Loading
The CXI gel string installation procedure is as follows:
Note: The CXI relies on the gel string being taped securely to the rollers. Be sure the
roller is clean and use good quality GAFF tape. The tape length should be 2/3 of the
roller length and apply the tape "lengthwise" on the roller.
1. Put the color changer on table, mounting plate down with the 4 pushbuttons
toward you, remove the front cover
2. The back gel string is yellow-magenta
a. tape the "yellow end" of gel string to the lower left roller, roll the gel string
onto the lower left roller
b. holding the gel string, wind up the lower right roller 6 turns and tape the
gel string on
3. The front gel string is magenta-cyan
a. tape the "magenta end" of gel string to the upper left roller, roll the gel
string onto the upper left roller
b. holding the gel string, wind up the upper right roller 6 turns and tape the
gel string on
4. Replace the front cover
CXI Specifications
End to end speed:
3 seconds
Models: 4560, 7200, 7220, 7240
4 seconds
Models: 12210, 16130, 16050
Fan: Multiple speed - normal
- limited
- remote control
Fuse: 3 Amp Slo Blo
Models: 4560, 7200. 7220, 12210, 7240
4 Amp Slo Blo
Models: 16050, 16130
Gelstring: Qty 2, 23 frames each
LED Indicators: Index mode (Yellow LED)
Control signal present (Green LED)
Power (Red LED)
Power supply compatibility:
Any Coloram II Power Supply
Signal termination: Not required
Weight:
4560 – 4-inch CXI Color Changer - 6.10 lbs./2.77 kg
7200 - 7.5-inch CXI Color Changer – 7.24 lbs./3.28 kg