Worksaver SDM40-72 Brush Cutter User Manual


 
33
6
SAFETY INSTRUCTIONS (continued)
Keep safety signs clean and legible at all times.
Replace safety signs that are missing or have become illegible.
Replaced parts that displayed a safety sign should also display the current sign.
Safety signs are available from your Distributor or Dealer Parts Department or the factory.
Be sure that the installation area is clean and dry.
Be sure temperature is above 50˚F (10˚C).
Decide on the exact position before you remove the backing paper.
Remove the smallest portion of the split backing paper.
Align the sign over the specified area and carefully press the small portion with the exposed sticky backing in
place.
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
Failure to follow proper procedures when mounting a tire on a wheel or rim can produce an explosion which
may result in serious injury or death.
Do not attempt to mount a tire unless you have the proper equipment and experience to do the job.
Inflating or servicing tires can be dangerous. Whenever possible, trained personnel should be called to service
and/or mount tires.
Always order and install tires and wheels with appropriate capacity to meet or exceed the anticipated weight
to be placed on the equipment.
How to Install Safety Signs:
SAFETY SIGNS
TIRE SAFETY
SDM40-60 PA RTS VIEW
REF. PART NO.
NO. NO. DESCRIPTION REQ'D.
1 650561 Deck Weldment, SDM40-48 1
2 650435 Gearbox - Comer 135.802 (SDM40-48) 1
6 650570 Blade, Cutter SDM40-48 2
12 650569 Linkage Lift Strap SDM40-48 2
33 650565 PTO Assembly, SDM40-48 1
SDM40-48 (4’ CUTTER) PA RTS LIST