Filter
Top Products
16 Service
MAN0003 (Rev. 11/30/2006)
Figure 9.
Remove the two depth skid bolts (1) and four motor
housing bolts (2) from one side as shown in Figure 10.
Figure 10.
Remove the depth skid and motor housing. Place the
motor housing in vice (3) as shown in Figure 11.
Figure 11.
Use an extension and a 1/2” twelve point socket to hold
motor bolts from the inside and remove the four 1/2”
nuts (4) from the bottom as shown in Figure 12.
Figure 12.
MOTOR INSTALLATION
Place the motor housing into a vice (1). Install the
motor and orient the motor ports (2) as shown in Figure
13.
Figure 13.
Install four 1/2” - 20 x 1-1/2” twelve-point bolts (3) and
four 1/2” - 20 (4) nuts as shown in Figure 14 and Figure
16. While using an extension and 1/2” twelve-point
socket, hold bolts from the inside and torque nuts to 85
lbs-ft. (115 N-m).
DP4
DP5
1
2
3
DP8
4
DP9
DP8
2
1