Filter
Top Products
Troubleshooting 13
MAN0003 (Rev. 11/30/2006)
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES SOLUTION
Drum will not rotate Auxiliary hoses are not hooked up
to skid steer
Inspect connections visually (make
sure QD’s are fully engaged).
There is an obstruction in one or
both of the auxiliary hoses
Remove and inspect hoses
visually.
One or more seals on the motor
have failed
Contact dealer.
Skid steer auxiliary hydraulics are
not operating properly
Refer to skid steer owner’s
manual.
Motor hoses are not plumbed
correctly
See “Hydraulic Assembly TL52” on
page 22. Verify correct hose
routing.
Drum rotates sluggishly Insufficient hydraulic flow from the
skid steer
Refer to skid steer owner’s
manual.
The hydraulic oil filter on the skid
steer is dirty
Refer to skid steer owner’s
manual.
One or more seals on the motor
have failed
Contact dealer.
Motor operates, but the drum does
not rotate
Cross bolt on coupler is sheared Inspect visually and repair as
needed.
Coupler splines are stripped Inspect visually and repair as
needed.
Motor shaft splines are stripped. Inspect visually and repair as
needed.
Oil is leaking from the motor area. One or more seals on the motor
have failed.
Contact dealer.
O-rings on fitting are damaged Visually inspect o-rings and
replace as needed.
Fittings are loose or damaged Refer to skid steer owner’s
manual.
Hydraulic hoses are loose or
damaged
Refer to skid steer owner’s
manual.
Insufficient cutting power One or more seals on motor have
failed
Contact dealer.
Oil filter on the skid steer is dirty Refer to skid steer owner’s
manual.
Insufficient auxiliary flow from skid
steer
Refer to skid steer owner’s
manual.
Relief valve on skid steer is not set
properly
Refer to skid steer owner’s
manual.