Filter
Top Products
44 Assembly
MAN0506 (Rev. 9/5/2008)
Install Hose Clamps
1. Place hose clamps (36) around hoses (11) and
center hoses between center plate.
2. Mark clamp holes in desired location on shedder
body and drill two 11/32" holes.
3. Secure hose clamps to shredder using 5/16 NF x
1-1/4 cap screws (20), flat washers (33), lock
washers (34) and hex nuts (35). See Figure 57.
Figure 57. Hose Clamp Installation
Connect Hoses to Tractor
NOTICE
■ Oil flow to hydraulic motor must not exceed 28
gpm.
1. Connect PRESSURE hose to a tractor rear remote
quick coupler that has a lever (handle) that can be
placed in the detent or locked position.
2. RETURN hose must be connected directly to the
tractor reservoir or to a specifically designated
motor return or ‘zero’ back pressure port.
Install Decals
Apply safety decals (24 & 25) to a clean surface on the
back of the shredder where they can be seen with out
obstructions. Install decals (25) on either side of the
hose assembly. See Figure 57.
Remove Deflector Kit
1022652 deflector kit must be removed from the shred-
der before using cutter kit. Deflector kit pushes material
away from the cutter kit and preventing material from
being cut.