Woods Equipment MX54T Lawn Mower User Manual


 
Assembly 27
MAN0253 (Rev. 3/10/2007)
Figure 27. Adjustment Rod Length
ADJUST CUTTING HEIGHT
1. With power unit and mower on a level surface and
power unit tire pressure set equally on both sides,
set cutting height on MX54/MX61 by moving the
height adjustment handle forward to lower the cut-
ting height and rearward to raise the cutting height.
Use the PowerTilt switch on MX54T/MX61T mod-
els.
2. In the high cut range, the caster wheel assembly
should be bolted through the lower hole in the
caster fork. Anti-scalp rollers should be installed in
the lower mounting hole. Use the high cut range for
the PowerTilt™ decks.
3. In the low cut range, the caster wheel assembly
should be bolted through the upper hole in the
caster fork. Anti-scalp rollers should be installed in
the upper mounting hole.
4. When the caster wheels are moved to a different
hole in the fork, it will be necessary to move the
rear pivot lift arm to the corresponding hole in the
power unit mounting brackets. See Figure 26, page
26.
5. If cut height does not correspond to the respective
position for the height adjustment handle on
MX54/MX61, the ground rod should be adjusted.
See Adjust Mower Deck, page 26. For MX54T and
MX61T, the cut height is aligned with the height
decal.
Apply Deck Height Decal
- PowerTilt Units
1. Turn power unit key to the ON position.
2. Activate rocker switch following decal instructions
on top of rocker switch bracket and set blade cut-
ting edge to 3 inches.
3. With mower deck level, place deck height decal
(75423) on top of height gauge bracket to corre-
spond to blade height. See Figure 28.
4. Check height indicator on the top of the actuator.
Blade height and indicator should be at the same
height.
Figure 28. Deck Height Indicator Decal Installed
ADJUST MOWER SIDE-TO-SIDE
Measure a similar spot to the ground on each rear
corner of the mower deck. If there is more than an
1/8" difference between sides, adjust lift rods until
sides are within 1/8".
MX61/MX61T Right Lift Rod Assembly 23.00"
MX61/MX61T Left Lift Rod Assembly 22.88"
MX61 Right Ground Rod Assembly 13.25"
MX54/MX51T Right Lift Rod Assembly 22.12"
MX54/MX51T Left Lift Rod Assembly 21.75"
MX54 Right Ground Rod Assembly 12.25"
(Rev. 6/8/2010)