Woods Equipment MX54T Lawn Mower User Manual


 
Assembly 25
MAN0253 (Rev. 3/10/2007)
Figure 21. PowerTilt Cable Connection
Figure 22. PowerTilt Cable Routing
3. Raise and lock seat in the up position. Locate the
seat support channel. (This is the channel which
the hood prop rod rests in.)
4. Attach red and black wires from the tilt power cable
to the auxiliary power connection under the right
side of the seat support channel. Red to purple;
black to black. See Figure 23.
NOTE: If your unit is equipped with a seat timer
delay, please use the schematic on page 46 to
assist in hooking up the power tilt cable to the timer
delay.
Figure 23. PowerTilt Cable Connection
FZ Series Power Units (without timer delay)
(Figure 24)
1. Disconnect seat switch wire harness from the main
wire harness terminal on right side of power unit.
2. Attach tower connector of PowerTilt harness (male)
to main wire harness on right front side of power
unit.
3. Attach receptacle connector (female) to the seat
switch.
4. Attach wires from lever switch to open terminal on
the wire harness. Secure wires to actuator using
plastic tie.
Figure 24. FZ Series Seat Connection
F Series Power Units (Figure 25)
1. Remove seat from the seat frame and turn upside
down. Save hardware for reuse.
2. Disconnect seat switch cable from the bottom of
the seat.
3. Attach connector with purple and black wires to the
seat switch.
4. Attach black wire of PowerTilt cable to main wire
harness connector previously removed from seat
switch (black to black).
5. Attach green wire of PowerTilt cable to opposite
side of the connector from main wire harness.
NOTE: Figure 25 shows the seat switch removed
from the bottom of the seat for picture clarification.
Seat switch does not have to be removed to make
these connections.
6. Attach seat to seat frame using hardware previ-
ously removed.
7. Attach wires from lever switch to open terminal on
the wire harness. Secure wires to actuator using
plastic tie.
NOTE: Remove wiring harness when replacing
power tilt deck with another attachment or use
jumper part #75521 and secure harness wiring
away from movine parts. Retaining the harness will
DP1T
Red
Black
Blue
Blue
Brown
Brown
Switch Tab
Red
DP3T
Black
Green
Purple
DP4T
Red
Male
Female
(Rev. 12/22/2007)