Woods Equipment MX54T Lawn Mower User Manual


 
24 Assembly
MAN0253 (Rev. 3/10/2007)
Figure 20. Wiring Connection - MXT Deck (SN 1100886 & above)
Wiring Connections
MXT Deck SN 1100886 and above
1. Lift seat/hood and remove jumper (75521) from
power unit’s main wire harness. (Located on front
left side by steering pivot.) Keep jumper; power unit
will not operate unless jumper or deck is attached.
2. Connect free end of deck safety harness to power
unit’s main wire harness where jumper was previ-
ously attached. Route harness through steering
pivot slot (weatherpack connector).
3. Connect free end of deck actuator harness to
power unit’s main wire harness. Route harness
through steering pivot slot. The main wire harness
connector is located underneath seat/hood by front
left steering pivot. (Packard 56 series connector.)
4. Tie strap harnesses to front of power unit frame.
Make sure wires are not pinched by steering link-
age during operation. Wire must also remain clear
of tire and not pull tight during tilt operation or deck
tilting side to side.
Connect Wiring Harness - PowerTilt™
Units MXT Deck SN 1100885 and below
NOTE: If you plan to use the MXT deck with the actua-
tor switch mounted on the deck, you must determine
which wire harness to use. Select harness 75407 for
FZ power units. Select harness 75433 for F-series
power units. These harnesses are provided with MXT
decks having SN 1100885 and below.
1. Attach red and black wires from the power tilt cable
(75407 or 75433) to the center terminals of the
rocker switch as shown in Figure 21.
2. Insert opposite end of power tilt cable through left
steering handle slot as shown in Figure 22.
(Rev. 1/11/2008)