Filter
Top Products
20 Parts
29936 (Rev. 5/18/2007)
Spindles and Blades
REF PART QTY DESCRIPTION
1
3761
1
Spindle assembly (for left hand rota-
tion)
2
5089
2
Seal
3
4114
1
Sleeve
4
4115
1
Sel-lock pin
5
4107
2
Bearing cone
6
4117
1
Housing with cups
7
4106
2
Bearing cup
8
1972
1
Grease fitting
9
28897
1
Spindle shaft with left hand thread
10
4110
1
Shoulder washer 2-1/4 diameter (for
L59 & FM48) -or-
10
13409
1
Shoulder washer 3 diameter (for
L306)
11
5081KT
1
16-13/16 medium suction blade (std
on RM48 and FM48) -or-
11
26875KT †
1
16-13/16 Low suction blade (optional
on RM48) -or-
11
23825KT
1
20-1/4 Medium suction blade (stan-
dard on L59) -or-
11
25997KT †
1
20-1/4 Low suction blade (optional
on L59) -or-
11
13404KT
1
24-1/2 Blade (Std on L306) -or-
11
28328KT †
1
24-1/2 Low suction blade (optional
on L306)
12
1015826
1
Blade bolt and washer kit (For FM48
& L59)
13
692
1
5/8 Flat washer
14
10635
2
5/8 ID Cup washer (for FM48 & L59)
14
13401
2
1" ID x 2-3/4 OD Cup washer (For
L306)
15
10718
1
Special 1-1/2 Long bolt (for FM48 &
L59) -or-
15
24184
1
Special 2-3/8 Long bolt (for L306)
16
13402
1
Clutch disk 3" diameter
17
13403
1
Blade stop
18
13405
1
Shim washer
19
12313
1
5/8 ID x 1" OD x 13/16 sleeve, hear
treated
20
13451
1
Special heat treated washer
22
4902
1
Spindle lock wrench (used on FM48)
-or-
22
2974
1
Spindle lock wrench (used on L59 &
L306)
23
3490 ‡
1
Blade bolt wrench
NOTE: Repair shaft 9 and repair sleeve 3 do not have a
hole drilled in them for pin 4. After new parts have been
assembled and proper bearing adjustment obtained, drill
a 3/16" diameter hole through sleeve and shaft. Drive in
Sel-lock pin to hold proper bearing adjustment.
NOTE: Left hand blade rotation for “L” series. (See page
_ for right hand rotation 59’s and yellow RM48’s.)
*
For maximum suction for difficult
mowing.
†
For use in sandy areas or where high
abrasive wear occurs on fin of stan-
dard blade.
‡
Used on mower prior to 1964.