Filter
Top Products
Assembly 29
15148 (Rev. 2/9/2007)
Figure 33. Leaf Mulcher L59
On L59 installations, align attachment angles with third
hole from front of mower and install between side
shields and deck angle. Secure with 3/8 x 1" bolts.
On L306 installations, align attachment angles with
fourth hole from front of mower and install between
side shield and deck angle. Attach with 3/8 x 1-1/2" bolt
and flanged lock nut. Use two 3/8" flat washers as
shims between side shield and deck angle rear hole.
On L59 installations, insert three 3/8 x 1-1/2" bolts
through holes drilled in front lip of mower. Insert a 5/8"
pipe spacer on each bolt between deck and leaf
mulcher. If pipe spacer is too long, substitute 3/8"
washers for spacers.
On L306 installations, insert three 3/8 x 1" bolts
through holes drilled in front lip of mower. Attach leaf
mulcher directly to front lip of mower.
On L59 mowers, drill four 7/16" holes in mower deck
using existing holes in leaf mulcher attachment plate as
templates. On L306, only two holes are required.
Insert 3/8 x 1" bolts through these holes and secure
with a lock washer and 3/8" nut
Tighten all bolts in leaf mulcher assembly.
Check blade clearance by turning each one by hand.
Should a blade contact a mulcher ring, reshape the ring
as necessary. Be sure to have 1/8" minimum clearance
between blade tip and mulcher.
1. Spacer
2. Leaf Mulcher
3. 3/8" Nut
4. 3/8" Lock Washer
5. 3/8" Flat Washer
6. Baffle Mounting Lug
7. Center Baffle
9. 3/8" Lock Nut
10. 3/8 x 1" Bolt
11. Angle Lug
12. 3/8 x 1-1/2" Bolt
13. Side Shield