Filter
Top Products
38 Assembly
MAN0390 (Rev. 4/6/2007)
Install Hydraulic Hose
On pull-type units with optional hydraulic cut-
ting height adjustment, use a single-acting cylinder
with a maximum extended length of 28-1/4" (718
mm) from attaching point center to center.
NOTICE
■ If using a cylinder other than the one supplied
by Woods, make sure a breather fitting is installed
in the cylinder rod end port. Use a restricter fitting
in the base end port to dampen the cutter lowering
action.
1. Install reducer bushing (9) and restricter swivel
elbow (10) in port at base end of cylinder (8).
Position elbow to point toward front of cutter.
NOTE: Make sure there is a breather fitting
installed in the rod end port.
2. Connect hose (11) to elbow (10).
3. Install optional stroke control kit (14) to cylinder
rod. Stroke control kit is used to set cut height.
Figure 33. DS96 Pull-Type Rear Half Installation
1. Tailwheel
2. Wheel hub
3. 15" Steel rim
4. 21" Solid tire -or-
4. 22" Aircraft tire -or-
4. 29" Aircraft tire
5. Attitude rod
6. Spacer
7. Transport lock-up
8. Hydraulic cylinder
9. Reducer
10. Elbow, restricter
11. Hose, 156"
12. Ratchet
13. Clevis pin, 1.0 x 2.26
14. Stroke control kit
15. Headless pin, 1 x 4-1/2
16. Headless pin, 1 x 4
30. Wheel bolt, 1/2 NF x 1-1/8
31. Cap screw, 1/2 NF x 1
32. Lock washer, 1/2
33. Cap screw, 1/2 NC x 3
34. Flange lock nut, 1/2 NC
35. Cotter pin, 1/4 x 1-1/2
36. Hex nut, 1 NC
37. Flat washer, 1"