Filter
Top Products
Assembly 33
MAN0450 (10/28/2005)
Figure 22. Pump Installation
ATTACHING BACKHOE TO TRACTOR
Remove backhoe from pallet and position on level sur-
face. Back tractor as near as possible and center on
backhoe.
Remove seat and upper support before attaching back-
hoe to tractor.
Service optional hydraulic reservoir by filling to full
mark on dipstick (approximately 5-1/2 to 6 US gallons).
When backhoe is mounted and operated, it will be nec-
essary to add more fluid to reservoir. Install cap (2).
IMPORTANT
■ Fill with clean oil. Do not mix oil types or
grades.
Use type A or F Automatic Transmission Fluid, SAE
Motor Oil or #303 Hydraulic Fluid.
1. Tank
2. Breather cap w/dipstick
3. Elbow, 3/4 NPTM x 3/4 NPSM
4 Filter & housing assembly
6. Adapter, 1/2 NPTF x 3/4 NPTM
7. 3/8 NC x 3/4 Carriage bolt
8. 3/8 Flange lock nut
9. Tank strainer
10. Adapter, 1-1/4 NPTM x 3/4 NPTF
11. Elbow, 3/4 hose 90°
12. 1/2 Hose clamp
13. Hose, 3/4 x 36"
14. Fitting, 90°
15. Adapter, 1-1/16 ORBF x 1-5/8 ORBM
16. Pump
17. Elbow, 3/4 JICM x 1-1/6 NPTM 90°
18. Pump mounting bracket
19. 1/2 NC x 1-1/2 Cap screw GR5
20. 1/2 NC Lock nut
23. Hose, 30" x 3/4 JICF x 1/2 NPTM
24. Hose, 50" x 3/4 JICF x 3/4 JICF
Recommended Oils and Temperature Ranges
(Do not mix oil grades or types)
SAE Hydraulic
Transmission Fluid. . . . . . . . .All Temperatures
Type A or F ATF. . . . . . . . . . .All Temperatures
SAE 30-30W . . . . . . . . . . . . . 90° F and above
SAE 20-20W . . . . . . . . . . . . . . . . . 35° - 90° F
ASAE 10-10W . . . . . . . . . . . . 35° F and below