Filter
Top Products
Owner Service 21
MAN0450 (10/28/2005)
OPTIONAL HYDRAULIC PUMP SYSTEM
Daily, check the fluid level in reservoir with filler cap
dipstick. Contamination will shorten the life of hydraulic
system components. Change oil and filter after first 20
hours of operation and then every 200 hours of opera-
tion or annually, whichever occurs first. In extremely
dusty or dry conditions, more frequent changes may be
necessary. System capacity is approximately 5-1/2 to 6
U.S. gallons.
Drain the oil into a suitable container and dispose of
properly in a manner compatible with the environment.
IMPORTANT
■ Fill with clean oil. Do not mix oil types or
grades.
ENGAGE PTO AND RUN AT IDLE FOR 5 MINUTES,
THEN CHECK OIL LEVEL. Add fluid as necessary.
CLEANING
After Each Use
● Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Inspect machine and replace worn or damaged
parts.
● Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
● Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Remove the remainder using a low-pressure water
spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
● Inspect machine and replace worn or damaged
parts.
● Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
● Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
Recommended Oils and Temperature Ranges
Do not mix oil grades or types
SAE Hydraulic
Transmission Fluid. . . . . . . . .All Temperatures
Type “A” or “F” ATF . . . . . . . .All Temperatures
SAE 30-30W . . . . . . . . . . . . . 90° F and above
SAE 20-20W . . . . . . . . . . . . . . . . . 35° - 90° F
ASAE 10-10W . . . . . . . . . . . . 35° F and below