Filter
Top Products
30 Assembly
MAN0680 (11/30/2007)
Disassemble Shipping Unit
Refer to Figure 29.
1. Position cutter flat and place a block underneath
the rear of the cutter to raise it off the ground.
2. Remove all parts that are wired or strapped to
cutter. Remove parts from manual tube and
hardware that is securing tailwheel bracket (3) and
brace arms (8) to cutter.
ASSEMBLE CUTTER
Install Tailwheel
Figure 30. Tailwheel Installation
1. Attach tailwheel bracket (3) to cutter at the
tailwheel pivot holes (A) using cap screws (35) and
flange lock nuts (36).
2. Select desired height adjustment holes (C), and
secure tailwheel bracket with cap screws (35) and
flange lock nuts (35). Cutting height adjustment will
be necessary when cutter is fully assembled. See
“Cutting Height Adjustment” on page 15.
3. Raise rear of cutter and insert tailwheel assembly
(17) with two washers (49) into tailwheel bracket
(3). Secure with o-ring (50), washer (51), and spiral
pin (52).
4. Place diagonal brace bars (4) on the inside of
frame rails and attach to diagonal brace mounting
holes (A). Secure using cap screws (13) and flange
lock nuts (14).
Connect A-Frame Arms
1. Rotate A-frame arms (6) and break link (7) forward
and up.
2. Attach brace arms (8) to the break link (8) using
cap screw (42), sleeve (11), and flange lock nut
(36). See Figure 31.
Figure 31. Brace Arm Connection
A. Tailwheel pivot hole
B. Brace arm mounting hole
C. Height adjustment holes
3. Tailwheel bracket
8. Brace arms
17. Tailwheel assembly
35. 5/8 NC x 2 Cap screw
36. 5/8 NC Flange lock nut
49. Washer, .18 x 1.62 x 3
50. O-Ring
51. Washer
52. Spiral pin 3/8 x 2
DP33
36
6
42
8
7
11
6. A-Frame arms
7. Break link
8. Brace arms
11. Sleeve, .628 x 1.0 x 1.25
36. 5/8 NC Flange lock nut
42. 5/8 NC x 2-3/4 HHCS GR5