Filter
Top Products
18 Parts
29932 (Rev. 8/10/2007)
SPINDLE ASSEMBLY
NOTE: Repair items shaft (9) and sleeve (3) do not
have a hole drilled in them for pin (4). After new parts
have been assembled and proper bearing adjustment
obtained, drill a 3/16 diameter hole through sleeve and
shaft. Drive in Sel-lock pin to hold proper bearing
adjustment.
REF PART QTY DESCRIPTION
1 4116 1 Spindle
2 5089 2 Seal
3 4114 1 Sleeve
441151Pin
5 4107 2 Bearing cone
6 4117 1 Housing with cups
7 4106 2 Bearing cup
8 1972 * 1 Grease fitting
9 4105 1 Spindle shaft
10 4110 1 Shoulder washer
11 6950KT 1 20-1/4 Medium suction blade
(std for 59) -or-
11 26559KT † 1 20-1/4 Low suction blade
(optional for 59)
12 10658 1 5/8 NC x 1-1/2 Nylok bolt
13 3490 1 Blade bolt wrench (used prior to
1964
14 2974 1 Spindle lock wrench
16 10635 2 5/8 Cup washer
17 692 * 1 5/8 Flat washer
18 1015825 1 Blade bolt & washers
(complete)
* Obtain locally, standard hardware
† For use in sandy areas or where
high abrasive wear occurs on fin
of standard blade.