Filter
Top Products
Mount Installation 7
MAN0469 (9/9/2005)
Torque Hardware
Torque hardware to specifications listed below.
Slide fuel tank back into position and secure.
Install Grill Guard (Optional)
1. Install grill guard bracket (10) to the right side of
tractor frame in the lower set of holes using two
cap screws (14), and hardened flat washers (17).
Repeat for left side.
2. Place grill guard (11) between brackets (10) and
secure using two cap screws (16) and four hex
nuts (15). Secure hex nuts together but leave grill
guard loose, it must be able to pivot freely. This
allows the grill guard to swing down for
maintenance.
3. Swing grill guard to the up position and secure
using two clevis pins (12) and two klik pins (13).
4. Torque cap screws (14) to 270 lbs-ft.
10. 1015429 Grill guard bracket
11. 1015431 Grill guard
12. 21332 1/2 x 1-1/2 Clevis pin
13. 22411 3/16 x 1 Klik pin
14. 307553 M20 x 2.5P x 50 mm Cap screw
15. 307863 M16 x 2.0P Hex nut
16. 34766 M16 x 2.0P x 60 mm Cap screw
17. 57798 3/4 Hardened flat washer
Figure 9. Grill Guard Installed (Typical)
Figure 10. Grill Guard Installation
TORQUE SPECIFICATIONS
Ref Cap Screw Qty
Wrench
Size Required Torque
4 M20 x 2.0P x 60 mm 2 30 mm 270 lbs-ft (367 N-m)
5 M20 x 2.5P x 50 mm 4 30 mm 270 lbs-ft (367 N-m)
8 M16 x 2.P x 50 mm 4 24 mm 125 lbs-ft (169 N-m)
DP7
14
17
10
13
12
11
15
16
10
15
CD6756-2