Filter
Top Products
4 Mount Installation
MAN0469 (9/9/2005)
LOADER MOUNT INSTALLATION
Tractor Preparation
■ Only use 211822 Loader Mounting Kit for
mounting Woods 1020/1027 loaders on Massey
Ferguson
®
5425, 5435, 5445 or Challenger
®
MT425B, MT445B tractors. Any other use or modi-
fication of this mounting kit may result in serious
injury or death.
IMPORTANT
■ This equipment must be assembled and
installed on the customer’s tractor by the Woods
dealer. Dealer must thoroughly inspect equipment
and complete each item on the PRE-DELIVERY
CHECK LIST, DELIVERY CHECK LIST, and PROD-
UCT REGISTRATION from the Loader Manual
before equipment is released to the customer.
■ Clean threaded holes in the tractor chassis
thoroughly, using a tap of the proper size. Paint,
rust or debris in the threads may not permit cap
screws to be installed and tightened correctly.
For installing this mounting kit, references to right, left,
forward, and rearward directions are determined from
the operator’s position in the tractor seat.
1. Shut off engine and set parking brake during
installation.
2. Remove the tractor’s front fenders if so equipped.
Front fenders can not be used with loader.
3. Remove the tractor front weights and front weight
bracket, if equipped.
4. Set front tire width to approximately 64". See
Figure 1.
NOTE: Maximum front tires size for use with the
1020 or 1027 loader is 14.9R24.
5. Remove tool box from under right side of cab, if
equipped.
6. Loosen steel bands from around fuel tank on left
side of tractor and slide tank out away from
tractor.
7. Remove hardware and spacers from the bottom
of cab support brackets. See Figure 2. Save bolts
for later use.
NOTE: The temporary removal of these parts will
allow access to mounting areas on the tractor.
Figure 1. Tire Adjustment (FWA Models)
Figure 2. Right Cab Support Bracket, Bottom View
64"
SC86VAR
Spacer
Cab Support
Bracket
DP1a