Filter
Top Products
Installation 9
MAN0728 (8/15/2008)
Verify Control Movements
1. Mount loader to tractor: Remove mount pins
from loader uprights. Align tractor with loader and
slowly drive tractor into loader. Shut off tractor.
2. Connect loader feedline hoses to tractor hydraulic
remote control hydraulics couplers. See Figure 8
for hose connections.
3. Comply with all Safety Rules and start the tractor.
4. Mount loader to tractor by activating bucket
cylinders to raise or lower the loader uprights into
the loader mounts. Slowly advance tractor
forward, activating appropriate cylinders to
engage loader completely into mounts. Insert
mounting pins to secure loader.
5. Check that all hydraulic control lever positions
operate the loader movements correctly as
shown in Figure 9.
6. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect
properly. Loader control movements must be
correct before proceeding.
7. Once all loader functions are correct, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic
system and check oil level.
8. When hose routings and correct loader
operations are verified, identify each circuit by
placing a matching colored band around the male
and female quick couplers. The color-coded
bands will make reinstallation easier when the
loader is removed from tractor.
9. Before operating the loader, make sure that
the Pre-Delivery, Delivery, and Pre-Operation
Check Lists in the Loader Operator’s Manual
have been completed.
Figure 9. Single Lever Control Operation
● Handle Forward - Boom down
● Handle forward to limit - Float position
● Handle back - Boom up
● Handle to right - Dump bucket or attachment
● Handle to left - Rollback bucket or attachment