Filter
Top Products
8 Installation
MAN0579 (1/19/2007)
Install Crossmember
1. Place crossmember (7) in front of drawbar
bracket and secure using two cap screws (15)
and hardened flat washers (17).
2. Secure to right and left tractor brackets using four
(two per side) cap screws (12), eight (four per
side) hardened flat washers (17) and hex nuts
(20).
7. 1024052 Crossmember
12. 902 5/8 NC x 2 HHCS GR5
15. 307431 M16 x 1.5P x 45 mm HHCS
17. 57817 5/8 Hardened flat washer
20. 230 5/8 NC Hex nut
Figure 8. Undermount Installed
Figure 9. Undermount Installation
Torque Mounting Hardware
7
15
17
DP6
17
12
TORQUE SPECIFICATIONS
Ref Cap Screw Qty
Wrench
Size Required Torque
11 5/8 NC x 3-3/4 HHCS GR5 4 15/16" 170 lbs-ft (230 N-m)
12 5/8 NC x 2 HHCS GR5 10 15/16" 170 lbs-ft (230 N-m)
14 M16 x 1.5P x 60 mm CL 10.9 8 24 mm 184 lbs-ft (250 N-m)
15 M16 x 1.5P x 45 mm 10 24 mm 133 lbs-ft (181 N-m)