Filter
Top Products
Installation 5
MAN0579 (1/19/2007)
BACKHOE SUB-FRAME INSTALLATION
Tractor Preparation
■ Only use 1023000 4-Point Sub-Frame Mount-
ing Kit for mounting Woods BH90-X backhoe on
Kubota
®
M8540 and M9540 2WD and FWA cab
tractors with either Woods LU132, 1020, 1027
loaders or Kubota LA1153 loader. Do not mount
backhoe to tractors not equipped with front end
loader. Any other use or modification of this
mounting kit may result in serious injury or death.
For installing this sub-frame, references to right, left,
forward and rearward directions are determined from
the operator’s position in the tractor seat.
Leave all hardware loose until sub-frame has been
completely installed or otherwise specified in the
instructions.
Do not install 1023000 4-point sub-frame on a tractor
without a Woods or Kubota loader attached.
Place jackstands under rear axle and remove both
rear tires.
Remove 3-point arms and anti-sway bars from the
tractor. Store for later use when backhoe is removed.
Remove anti-sway link bracket from right and left
sides of tractor axle. See Figure 1.
Remove 3-point cylinder brackets from right and left
sides of tractor. Save hardware for reuse.
Figure 1. Right Anti-Sway and Cylinder Brackets
Cylinder Bracket
DP1
Anti-Sway Bracket