Filter
Top Products
10 Installation
MAN0579 (1/19/2007)
HYDRAULIC INSTALLATION
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety gog-
gles. Hydraulic fluid under pressure can easily
penetrate skin and will cause serious injury or
death.
Make sure that all operating and service per-
sonnel know that if hydraulic fluid penetrates
skin, it must be surgically removed as soon as
possible by a doctor familiar with this form of
injury or gangrene, serious injury, or death will
result. CONTACT A PHYSICIAN IMMEDIATELY IF
FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking
before starting power unit or using equipment.
Check and route hoses carefully to prevent dam-
age. Hoses must not be twisted, bent sharply,
kinked, frayed, pinched, or come into contact with
any moving parts. Operate moveable components
through full operational range to check clear-
ances. Replace any damaged hoses immediately.
Install Hydraulic Fittings and Hoses
1. Attach bulkhead adapter (4), adapter (7) and
male quick coupler (5) to bulkhead adapter
bracket (13).
2. Attach bulkhead adapter bracket assembly to the
inside of right rear fender using two cap screws
(14), flat washers (15),and hex nuts (16).
3. Attach end of hose (2) to the back side of bulk-
head adapter (4).
Continued on next page.
Figure 11. Bulkhead Adapter Bracket Installed
DP19
7
15
14
16
4
5
2