Filter
Top Products
7
OPERATION
KNOW YOUR TRIMMER
READTHISINSTRUCTIONMANUALANDSAFETYRULESBEFOREOPERATING YOURUNIT.
Compare the illustrations with your unit tofamiliarize yourself with thelocation ofthe variouscontrols
and adjustments. Save this manual for future reference.
Fuel Mix
Fill Cap
Starter
Handle
STOP Switch
Spark Plug
Primer Bulb
Line Limiter Blade
Shield
Shaft
Locking Sleeve
AssemblyTrimmer
Head
Models:
W25CB, W25CF,
W25CBK, W25CFK
Models:
W25SB, W25SF,
W25SBK, W25SFK
Line Limiter Blade
Shield
Shaft
Trimmer
Head
Models:
W25CBK, W25CFK,
W25SBK, W25SFK
Assist Handle
Muffler
Throttle Trigger
STOP SWITCH
TheSTOPswitchis usedtostoptheengine.To
stoptheengine,pushandholdtheswitchinthe
STOP position until the engine stops.
PRIMER BULB
ThePRIMERBULBremoves airfromthecar-
buretor and fuel lines and fills them with fuel.
This allows you to start theengine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
BEFORE STARTING ENGINE
WARNING:
Besureto read thefuel
information in the safety rules before you
begin. If you do not understand the safety
rules, do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
WARNING:
Remove fuelcap slowly
when refueling.
HELPFUL TIP
Toobtainthecorrect oilmix
ratio, pour 3.2 ounces of
2--cycle synthetic oil into
one gallon of fresh gas.
IMPORTANT:
This equipmentis designedto
operate on unleaded gasoline with a minimum
87 octane (R+M/2 method), with ethanol
blendedupto10%maximumbyvolume(E-10).
Beforeoperation,gasolinemustbemixedwitha
goodquality synthetic 2-cycleair-cooledengine
oil designed to be mixed at a ratio of 40:1.
Poulan/WEED EATER brand synthetic oil is
recommended. Mix gasolineandoil at aratio of
40:1. A 40:1ratio isobtainedbymixing3.2fluid
ounces ofoilwith1 gallonof unleadedgasoline.
DO NOT USE automotive oil or marine oil.
These oils will cause engine damage. When
mixing fuel, follow instructions printed on
container. Once oil is added to gasoline, shake
container momentarily to assure that the fuel is
thoroughly mixed.