Weed Eater 952711895 Trimmer User Manual


 
6
NOTE: If shield is not properly installed, dam-
age to unit (including motor failure) will resu lt.
1. Place the shield onto the motor housing.
Ensure the cutting head remains free to
rotate and the line is not caught between
the shield andthe motor housing (see fol-
lowing illustration).
Motor Housing
Shield
Line Limiter
Pin
Cutting Head
2. Align the installation arr ow on the shield
with the installation arrow on the motor
housing as shown.
Installation
arrows
3. Twist t heshield asillustrateduntil itsnaps
secu rely into place. Make sure the shield
is assem bled to the unit as shown i n the
illustration below and in the KNOW
YOUR TRIMMER sectionof this manual.
WHEEL ASSEMBLY
1. Fit the two h alves of the wheel together
(see illustration).
Wheel
2. At tach the wheel to the tr im m er. Make
sure the wheel is fitted into the grooveon
the motor housing.
Groove
Motor
Housing
3. Clip the wheel together securely on the
other side. The wheel should turn freely.
INSTALLATION OF ASSIST HANDLE
1. Pr ess the two butt ons on the sides of the
switch handle.
Button
Button
Assist Handle
2. Push the assist handle over the buttons
and release the buttons.
3. Adjustthe handleto t hemostcomfortable
operatingposit ionby pressing thebuttons
and moving the handle.