Filter
Top Products
11
Air Vents
S Remove the wheel by pressing one of the
buttons. Cleanthe wheeland groove o nthe
motor housing with a sof t brush. Reinst all
wheel (see ASSEMBLY section).
Groove
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
WARNING: Disconnect unit from
power source before ser vicing.
1. Pr ess and hold in the two cap release
latches.
2. Pull cap away from the hub.
Cap
Cap
release
latch
Spool
Hub
Eyelet
3. Remove old spool.
4. Clean entire surface of hub and sp ool.
5. Replace with a pre--w ound spool or cut
two lengthsof 13feet(4meters) of0.065″
(1.65 mm) diameterWEE DEATERbrand
line. Use of heavier lines could overlo ad
and damage unit.
WARNING: N ever use wire, rope,
string,etc., which canbreakoffandbecomea
dangerous missile.
6. Insertoneend ofthelineabout 1/2 inch(1
cm) into one of the sm all holes in the up-
per section of the inside of the spool.
7. Wind the line evenly and tightly onto the
spool. Wind in the direct ion of the arrow
found on the spool.
8. Push the lineinto the notch, leaving 3to 5
inches (7 -- 12 cm) unwound.
9. Re p eat on the lower sect ion of the spool.
Notches