Filter
Top Products
13
TROUBLE CAUSE REMEDY
Trimmer head
stops under a
load or does not
turn when switch
is pressed.
1. Allow tip of line to do the cutt ing.
2. Contact your authorized se rvi ce dealer.
3. Check Breaker Box.
4. Remove debris.
Line does not
advance, line is
too short, or
trimmer vibr ates.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 in. (1.65 mm) dia. line.
4. Remove spool ca p and spool. Manually
feed line. Reinstall cap and spool. See
Automatic Line Feed System section.
5. Rewind line tightly and evenly. Check
that line is in correct section of spool.
6. Clean unit.
Excessive noise
when unit is run-
ning.
1. Allow the motor to reach full speed
before use .
2. Rewind line tightly and evenly. See
Automatic Line Feed System section.
3. Contact your authorized service dealer .
Line releases
continuously.
1. Check line routing.
2. Replace spool.
TROUBLESHOOTING TAB LE
1. Line im properly
routed in head.
2. Spool damaged.
1. Motor has not reached
full speed before u se.
2. Too much line has been
released from the spool.
3. Line lim iter pin m issing
from shield.
1. Line im properly routed
in head.
2. Line im properly
wound into spool.
3. Inco rrect line size
4. Not enough line
outside of head.
5. Manual line feed not
working.
6. Dirt buildup on unit.
1. Cr owding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown circuit breaker.
4. Debr is st opping head.
Line usage is
excessive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Line improperly rout e d
in head.
2. Line size is incorrect.
3. Crow ding line against
material being cut.
4. Spool worn or damaged.
WARNING: Alwa ys stop u nit anddisconnect from t he powersource before p erforming
all of the recomm ended remedies below except remedies that r equire unit to b e operating.
Wheel st ops
turning.
1. Dirt or debris buildup
on wheel or in groove.
1. Clean wheel and groove o n motor
housing (see Maintenance section).