Filter
Top Products
5
ASSEMBLY
WARNING: I freceivedassembled ,
ensur e your unit is properly assem bled
and all f astener s ar e secure.
ATTACHING THE BLOWER TUBE
1. Align the grooves onthe blowertube
withthegrooves onthebloweroutlet.
2. Pushtheblowertubeontoth eblower
outletuntilitsnapsintoplace (tubeis
secured by yellow tube release bu t-
ton).
3. To remove the blower t ube, press the
tube release button while pulling on
tube.
Blower T ube
Blower outlet
Tube Release Button
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as
shown on nameplate of the unit to
power your blower.
Theextensioncordusedtoreachthe
power source must be:
D Specifically marked as suitable for out-
dooruse.The cordmustbemarkedwi t h
the suffix “W”.
D Heav y e noug h to c arry full curr e nt f rom
the powersource to the unit.Otherwi se,
loss of power and overheat i ng can oc-
cur causing damage to unit. Ref er to
tab le for minimu m wire gauge recom-
mendations. The cord m ust be marked
wit htheproperwiregauge.(Appropr i ate
extension cords are avai labl e. ) Do not
use multi pl e cords.
D In good condit i on. Cord i nsulati on must
be intact wi th no cr acks ordet eriorati o n.
Plug connectors must be undamaged.
DO NOT use mul tipl e cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOL TS
25 FT. 50 FT. 100 FT.
120
16
A.W.G.*
16
A.W .G.*
*American WireGauge
14
A.W.G.*
Secur e the extension cord to the uni t by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
rece ptacle into the rece ssed p lug.
CAUTION: Failuretousecordretain-
er could result in damage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit