Watlow Electric 988 Weather Radio User Manual


 
4.28 WATLOW Series 988 User’s Manual
Setup Menus, Chapter 4
Setup-Output
Output 4
Select the alarm condition for output 4.
[`AL4] de-energizes output 4 in an alarm condition.
[AL4n] energizes output 4 in an alarm condition.
[`Ot4] This prompt appears only on controllers equipped with output 4
hardware for a relay (98_ _-_ _ _ _-_B_ _, 98_ _-_ _ _ _-_D_ _ ,
98_ _-_ _ _ _-_E_ _ or 98_ _-_ _ _ _-_K_ _) or switched dc (98_ _-_ _ _ _-_C_ _).
Default
[`AL4] [AL4n]
[`Ot4] [`Ot4]
Alarm 4
Select the alarm type for alarm 4.
[`Pr1] uses a process signal from input 1.
[`dE1] uses a deviation from the input 1 signal.
[`Pr2] uses the process signal from input 2. This prompt does not
appear if the controller is not equipped with input 2 hardware or if
[`In2] is set to [``no] or [`Ei2].
[`dE2] uses a deviation from the input 2 signal. This prompt does not
appear if the controller is not equipped with input 2 hardware or if
[`In2] is set to [``no] or [`Ei2].
[rAtE] uses the rate of change at input 1 in degrees per minute.
[`AL4] This prompt appears only on controllers equipped with output 4
hardware for a relay (98_ _-_ _ _ _-_B_ _, 98_ _-_ _ _ _-_D_ _ ,
98_ _-_ _ _ _-_E_ _ or 98_ _-_ _ _ _-_K_ _) or switched dc (98_ _-_ _ _ _-_C_ _).
Default
[`Pr1] [`dE1] [`Pr2] [`dE2] [rAtE] [``no]
[`AL4] [`AL4] [`AL4] [`AL4] [`AL4] [`AL4]
˜
NOTE:
See Chapter 7 for
more information
on alarms.
[`Ot4]
[`AL4]
C4.wc 5/14/1999 8:48 AM Page 4.28