Filter
Top Products
MAINTENANCE
CHECK OIL LEVEL
regularly
-
after each
five hours ol
operatio-n-trSFE orL LEVEL
ts MAtNTAINED.
CHANGE OIL
after first five hours
of operation.
Thereafter
change every 25 hours
of operation.
Remove oil
drain
plug
and
drain oil
while
engine
is warm. Replace drain
plug.
Remove oil
fill
plug
or oil-minder and
refill with new oil
of
proper gr;de.
Replace oil
fill
plug
or oil-minder.
CHANGE
OIL
(GEAR
REDUCTION optional)
Remove oil
level
plug
and
oil
fill
plug.
Drain oil every
100 hours of
operation.
To refill,
pour
10W-30 oil
into filler
hole
until
it
runs
out
level
check
hole.
Replace both
plugs.
Oil
fill
plug
has a vent hole and
must be installed on
top of
gear
case
cover.
TO SERVICE AIR
CLEANER
..OIL
FOAM''
AIR CLEANER
Clean and re-oil foam
element
at three month intervals
or
every 25 hours, whichever
occurs
first.
NOTE:
Service
air
cleaner
more
often under dusty con-
ditions.
1. Remove
screw.
2. Remove
air cleaner carefully
to
prevent
dirt
from
enter-
ing
carburetor.
3.
Take
air cleaner apart and clean.
a.
WASH foam
element
in a liquid detergent and water
to
remove
dirt.
b. Wrap foam in
cloth
and
squeeze
dry.
c.
Saturate
foam with engine oil. Squeeze to
remove
ffi
4. Reassemble
parts
and fasten to carburetor securely with
screw.
ASSEIIBLE
ELEH€I{T
SO LIP
EXTEIIDS OVER
:REOGE OFAIR
CtEAIif
OIL
FOAM AIR CLEANER
DUAL
ELEMENT
AIR CLEANER
Clean
and re-oil
foam
pre-cleaner
at
three month
intervals
or every
25
hours,
whichever
occurs
first.
NOTE: Service
more often under
dusty
conditions.
1. Remove
knob
and cover.
2.
Remove
foam
pre-cleaner
by sliding
it
off of
the
paper
cartridge.
3. a.
Wash
foam
pre-cleaner
in liquid
detergent
and
water.
b.
Wrap
foam
pre-cleaner
in
cloth
and
squeeze
dry.
c.
Saturate
foam
pre-cleaner
in
engDe
oil.
Squeeze
to
remove
excess oil.
4. Install
foam
pre-cleaner
over
paper
cartridge.
Re-
assemble
cover
and screw
down
tight.
Yearly
or every 100 hours, whichever occurs
first, remove
paper
cartridge.
(Service
more
often
if necessary.) Clean
by tapping
gently
on
flat
surface.
lf very
dirty,
replace
cartridge, or wash
in
a
low
or
non-sudsing detergent and
warm
water solution. Rinse thoroughly
with llowing water
from inside
out until water
is
clear. Cartridge
must
be air
dried thoroughly
before using.
CAUTION:
Petroleum
solvents are
not
to be used
to clean
cartridge. They may cause deterioration of
the cartridge.
DO NOT
OIL CARTRIDGE.
DO NOT USE PRESSURIZED
AIR.
PLUG
\-----t
r\ I t",'.