Filter
Top Products
53
Maintenance Instructions
REPLACING/REPAIRING/
ADJUSTMENTS
Reinstall the blades following procedure from Sharp-
en Mower Blades instructions. If blades are re-
placed, always use Walker original equipment
blades to ensure safety and optimum performance.
The quality and performance of replacement blades
offered by other manufacturers cannot be guar-
anteed, they could be dangerous.
ADJUSTMENTS
Transmission Control
IMPORTANT: The proper adjustment of the tran-
saxle control stops is essential for efficient operation
and life of the transaxle. These stops are properly ad-
justed at the factory and should only require read-
justment if the transaxle or related control linkage is
removed or changed.
NOTE: It would not be unusual for a new machine,
after initial 5 or 10 hours of operation, to begin to not
travel straight (this is due to the break-in of the tran-
saxles).
Steering Lever Position Adjustment - Step 1
NOTE: For proper operation, the steering levers
should be adjusted to sit evenly using the following
procedure.
1. Examine the steering levers to make sure they
are parallel front to back in relation to one an-
other. If they are not equal, adjust accordingly.
(The handles may or may not be even at this
point.)
NOTE: The LH steering lever is non-adjustable.
This procedure will require adjustment of the RH
lever to make it even with the LH lever.
Lever Alignment
2. Adjust the position of the RH lever by turning the
stop bolt in the Speed Control Actuator in or out.
Turning the stop bolt in will make the RH lever
move back, and turning it out will make it move
forward. Tighten the locknut.
Stop Bolt Location
CAUTION
ALWAYS use genuine factory replacement
parts. Substitute parts CAN result in prod-
uct malfunction and possible injury to the
operator.
Levers should sit
parallel to each other
Stop
Bolt